Revolv 60,000 Btu 96% Afue Mobile Home Top Return Downflow 2-Stage Gas Furnace with Coil Cabinet

The Revolve MG2S Series Mobile Home Gas Furnace is designed for all sizes of manufactured and modular homes. These units incorporate high efficiency, reliability, and low maintenance. Units may be installed free standing in a utility room or enclosed in an alcove or closet. MG1 Series furnaces are available in A/C adaptable or A/C ready, with or without coil cavity box and many burner options.

Standard Features:

• 100% fired and tested: All units and each component (both mechanical and electrical) are tested on the manufacturing line.
• 2 Stage gas valve: Provides 2-stage thermostat control
• 2 Stage inducer: Optimizes efficiency on first stage heat and reduces sound levels.
• ECM blower: Designed to give a wide range of cooling and heating airflows.
• 40VA transformer included.
• Clean and quiet operation: Due to the unique design of in-shot burners, location of inducer and use of insulation.
• Fixed 30 second blower delay: At burner start-up assures a warm outlet air temperature at furnace start-up. Adjustable blower off settings (60, 90, 120 and 180 seconds).
• Dependable, hot surface ignitor: Innovative application of silicon nitride type igniter. Utilizes proven Smartlite® technology to extend iginiter life.
• Tubular primary heat exchanger: Heavy gauge aluminized steel heat exchanger assures a long life.
• Stainless steel secondary heat exchanger: Assures a long life.
• 60 second fixed cooling cycle blower-off delay (TDR): Increases cooling performance when matched with a Nortek Global HVAC coil.
• Sealed combustion approved for direct vent furnace, category IV venting system: May be vertically or horizontally vented using a two-pipe system for maximum flexibility in installation.
• LP convertible: Simple burner orifice (included w/unit)and gas valve regulator change for ease of convertibility.
• 3 amp fuse protection against low voltage shorts: Protects transformer and control board.
• Low voltage terminal board: For easy field wiring.
• Easy open pawl latch: Secures the door firmly for transit, yet allows easy removal for access.
• Appliance quality door: Protects against rust and other corrosion. Baked enamel finish allows for easy cleaning.
• Fully insulated cabinet: Insures minimized heat loss and quiet operation.
• Color coded wire harness: Designed to fit the components, all with quick-connect fittings for ease of service and replacement.
• Multi-speed ECM blower: Designed to give a wide range of cooling capacities. Switches on PCB, provide ultra easy motor speed selection. 40VA transformer included.
• Diagnostic lights for easy troubleshooting without counting flashes: Dedicated light for flame signal strength and 2 lights in combination to indicate all other fault codes with easy to recognize states without counting flashes.